Olympos HP-101 conversion to 0.2mm ?

[Papajohn]

Is it possible Olympos HP-101 to convert to 0.2mm by using the nozzle cap, needle cap, nozzle and needle bearing from an Iwata HP-B airbrush ?


Sent from my iPhone using Tapatalk

 

[DaveG]

the answer to this question is in this other thread based on the same question. I believe it was you that asked it . There is a LOT of info in the thread, so be sure to read through it.

short answer is yes - well, maybe not - I just read through the older thread, and it looks like the brush can use Iwata HP-C nozzles, which would make it a .3 set up - the info is all in the other thread.

http://www.airbrushforum.org/threads/olympos-hp-101-parts-compatibility-with-iwata.19141/