Y
Yams
Guest
I am sure there is already a thread out there, but I was wondering if anyone had experience with cheap touch up guns.
http://www.harborfreight.com/adjustable-detail-spray-gun-92126.html
This is what I was looking at, but I was wondering if my dual piston AB compressor can run it. It says it takes 3 CFM at 50 PSI, but I would only be running it at 20 - 25. My compressor can supply about 1.4 CFM not sure at what PSI though ): Is it even a possibility?
http://www.harborfreight.com/adjustable-detail-spray-gun-92126.html
This is what I was looking at, but I was wondering if my dual piston AB compressor can run it. It says it takes 3 CFM at 50 PSI, but I would only be running it at 20 - 25. My compressor can supply about 1.4 CFM not sure at what PSI though ): Is it even a possibility?