Dimitris
Mac-Valve Maestro!
ok guys and girls
not yet in much mood to explain what happened, but my cm-c commited suicide (with my help)....
The whole accident happened when my foot caught the air hose and dragged it. i had the crown cap on and the needle didn't got damaged, I checked the AB out and noticed that the needle was a tiny bit back of where it's supposed to be. Unscrew the nut, pulled the needle back-no problem, checked it (tip-bend anywhere-no problem), got it in, same position on front (bit back). Checked the nozzle with the magnifying lens-no problem at first sight but afterwards looked closer).
I wrote in vid the spray pattern so you could check it out, used some distilled water at 25 psi, but nothing seems to be wrong....except that pic where the needle seems retreaved. Throw some opinions please and any suggestions what to examine. Thanks.
Update:
while taking the pics, noticed the nozzle deformation... guess i'll be needing a new one
sorry for the long post, I'm counting on your opinion so I won't get robbed if i have to send it for very examined performance.
And please notice how relaxed i'm describing this..unfortunant accident (had to use these emoji's oneday...) having also my hp-c's o-rings swollen from restorer....right....
A lot of deformations...
not yet in much mood to explain what happened, but my cm-c commited suicide (with my help)....
The whole accident happened when my foot caught the air hose and dragged it. i had the crown cap on and the needle didn't got damaged, I checked the AB out and noticed that the needle was a tiny bit back of where it's supposed to be. Unscrew the nut, pulled the needle back-no problem, checked it (tip-bend anywhere-no problem), got it in, same position on front (bit back). Checked the nozzle with the magnifying lens-no problem at first sight but afterwards looked closer).
I wrote in vid the spray pattern so you could check it out, used some distilled water at 25 psi, but nothing seems to be wrong....except that pic where the needle seems retreaved. Throw some opinions please and any suggestions what to examine. Thanks.
Update:
while taking the pics, noticed the nozzle deformation... guess i'll be needing a new one
sorry for the long post, I'm counting on your opinion so I won't get robbed if i have to send it for very examined performance.
And please notice how relaxed i'm describing this..unfortunant accident (had to use these emoji's oneday...) having also my hp-c's o-rings swollen from restorer....right....
A lot of deformations...