M
Magickalhack
Guest
So, as the title says, I am having a bit of an air pressure issue with my airbrush. I have a super basic setup; badger 150-4 and a paasch d500 1/10hp compressor. No regulator. Based on what the I can find on the compressor it should run at about 20 psi which should be enough, however as I was trying to troubleshoot and clean my brush I noticed that while I had good airflow, there didn't seem to be enough pressure to pull even water up the tube.
Any help would be appreciated. I got this setup used 3 or so years ago, so I understand it could be time to replace stuff.
Sent from my SM-G950W using Tapatalk
Any help would be appreciated. I got this setup used 3 or so years ago, so I understand it could be time to replace stuff.
Sent from my SM-G950W using Tapatalk