B
BenTSH
Guest
Hi everyones
After one dozen of use with acrylic, Mr surfacer or alkyde and acrylic/urethane paints I never had problem and since yesterday I have bubble in the paint cup ( even at 15PSI ) so I've changed the nozzle's teflon seal and I still have the problem with the 0.4 but It seems too with my new 0.15 which has not been used with paint
If I quit the O-ring of the air cap to tighten it more and the nozzle's seal too I can reduce the bubbles but they are still annoying
So if it is not the seal would it be possible that it was the main body of the airbrush with a problem ???
I see there is a part inside the main body between the cup and the front cavity where the nozzle goes ( it is where the paint goes through ) but it is in addition into its side where is machinised the "air pipe" ( there is a small side rectangular hole ) so would it be possible there is a leak here ?
If I quit the nozzle and air cap I don't feel air in the cup but it is not a good test and it is hard to test it perfectly ( by closing up totally the air and paint pipes and looking if there is bubbles ) as I need to find a same screw as the air cap...
I like the Infinity because it is easy to clean and don't have the nozzle with a screw system like Iwate which afraid me a little but it seems it was maybe a wrong choice...
Thanks by advance
After one dozen of use with acrylic, Mr surfacer or alkyde and acrylic/urethane paints I never had problem and since yesterday I have bubble in the paint cup ( even at 15PSI ) so I've changed the nozzle's teflon seal and I still have the problem with the 0.4 but It seems too with my new 0.15 which has not been used with paint
If I quit the O-ring of the air cap to tighten it more and the nozzle's seal too I can reduce the bubbles but they are still annoying
So if it is not the seal would it be possible that it was the main body of the airbrush with a problem ???
I see there is a part inside the main body between the cup and the front cavity where the nozzle goes ( it is where the paint goes through ) but it is in addition into its side where is machinised the "air pipe" ( there is a small side rectangular hole ) so would it be possible there is a leak here ?
If I quit the nozzle and air cap I don't feel air in the cup but it is not a good test and it is hard to test it perfectly ( by closing up totally the air and paint pipes and looking if there is bubbles ) as I need to find a same screw as the air cap...
I like the Infinity because it is easy to clean and don't have the nozzle with a screw system like Iwate which afraid me a little but it seems it was maybe a wrong choice...
Thanks by advance