Hi guys. I came here in hope of some advice with the set up I'm using. First off I own a Iwata neo airbrush. I bought mainly for painting gundams. Now I dont have a very good air compressor for airbrushing (atleast that's what I assume) but I'm having major issues being able to paint fine lines. Im wondering If it's because the compressor is to big? What happens is if I turn the pressure down it wont hardly spray but after adjusting the pressure then it almost splatters on the parts. I am pretty inexperienced so that could have alot to do with it also. I attached a photo of the air compressor I use. The paint I use is creatix airbrush paint. If I'm just painting the peices solid I dont have any issues because I can just spray the part further away and its fine. I was trying to spray highlights on my primed parts and had a hell of a time. It either went on to thick because I was up close to the part trying to spray a fine line or I would just miss where I wanted the paint to land. I've been considering buying the Iwata Ninja but I airbrush in my bathroom and I'm not sure how loud the ninja will be since it stays on while painting. The one I use is super loud but it only takes a minute or so and its filled and then I airbrush. I know this post is jumbled and I apologize but any advice would be great. Thank you!. Oh I also have a iwata filter that is attached to my airbrush.