For Every Airbrush Artist!

Ready to get involved? Register for free and you won't see any google advertising!

Register

Alright, it's finally purchased...

Discussion in 'Open Bar!' started by Neural, Nov 27, 2018.


  1. Neural

    Neural Gravity Guru

    Joined:
    Jun 19, 2017
    Messages:
    186
    Likes Received:
    188
    Trophy Points:
    41
    Looking at the image again, I think I should have done the dagger strokes vertically to go with the grinds they are over. Oh well. I'm happy with how they came out (which is saying a lot). They are pointy on the ends, and fat in the middles.
  2. huskystafford

    huskystafford Needle chucking Ninja Very Likeable!

    Joined:
    Sep 1, 2017
    Messages:
    2,963
    Likes Received:
    3,330
    Trophy Points:
    126
    Location:
    Slovenia
    was wondering why you have that wrench beside your airbrush -.-
  3. Neural

    Neural Gravity Guru

    Joined:
    Jun 19, 2017
    Messages:
    186
    Likes Received:
    188
    Trophy Points:
    41
    LOL. That's just where it is currently. Had used it for easily tightening the air hose on the Talon (not overdoing it, just easier than the tiny wrench). I also have parts for the easel that need a small wrench to allow me to change the position of the support bars.

    edit: and before you ask: the Dremel abrasive wheel was left from when I took my dremel and brushed off the inside tip from the Talon to clean it up and try and figure out why it was causing backflow problems. :)
    huskystafford likes this.
  4. huskystafford

    huskystafford Needle chucking Ninja Very Likeable!

    Joined:
    Sep 1, 2017
    Messages:
    2,963
    Likes Received:
    3,330
    Trophy Points:
    126
    Location:
    Slovenia
    Sry, I needed to ask lol
    Neural likes this.

Share This Page