When to clean the nozzle

Try not to remove the nozzle unless you absolutely have to. As long as you haven’t allowed paint to dry in the brush a good end of day spray clean out should suffice,
The more often yo remove the nozzle the greater the risk of damage by dropping, over tightening, cross threading etc etc.
if you have an eclipse (self centring nozzle) then you could, if you really felt the need, remove it and soak it
 
Yeah, if your normal cleaning isn’t quite cutting it. Just use a small pot with cleaning fluid into the cleaner. You can fill the ultrasonic with water and just use cleaning solution in the smaller pot. I’d recommend a lid on the smaller pot.
I use ‘Decor’ condiment pots,
This one just has Createx restorer in it but I use the same type in the ultrasonic
image.jpg
 
Back
Top