JuanRi
Gravity Guru
I'd like to post a single way to turn the airbrush on a blower. To do it, You can use an old or cheap airbrush, a plastic connector and a needle or needle-probe. In my case I'm going to use a probe, It's a medical-use probe provided by a Luer connection (the usual connection for siringe-needle). But you can use a needle after sanding its tip.
You don't have to change the airbrush a lot.
In my case, I inserted the needle cup in a little piece of polyurethane hose and the needle in the other side. Then, screw the needle cup in the airbrush.The needle has to be hidden in the airbrush to avoid its damage. I use about 30 PSI to run it and it is very usefull for putting the water out after cleaning. Hope can be usefull. Thanks.
You don't have to change the airbrush a lot.
In my case, I inserted the needle cup in a little piece of polyurethane hose and the needle in the other side. Then, screw the needle cup in the airbrush.The needle has to be hidden in the airbrush to avoid its damage. I use about 30 PSI to run it and it is very usefull for putting the water out after cleaning. Hope can be usefull. Thanks.